Skip to content
Aviation Newsroom

Aviation safety

FAA orders stabilizer freeplay checks on 1,987 US 737s after pitch oscillations

By Michal Zembol

Published .

On 19 October the FAA told operators of certain 737 Next Generation aircraft to measure horizontal-stabilizer freeplay after reports that the nose had pitched up and down in flight. The rule covers 1,987 aircraft on the US registry and takes effect on 23 November. It does not apply to the 737 MAX.

The seal of the US Federal Aviation Administration.
Federal Aviation Administration.

The Federal Aviation Administration has ordered inspections of 1,987 Boeing 737s on the US registry after more than one operator reported the nose pitching up and down in flight. The rule was published on 19 October. It covers the 737-600, 737-700, 737-700C, 737-800, 737-900 and 737-900ER, the Next Generation models. It does not cover the 737 MAX, and it is separate from the type certificate the FAA issued for the MAX 10 on 20 October.

The FAA says those pitch changes came from excessive freeplay in the horizontal stabilizer, the small wing on the tail that holds the nose at the attitude the crew has set. Freeplay is looseness at the hinges the surface pivots on, and in the screw that drives it. If it is left uncorrected, the FAA says, the surface could flutter and the crew could lose control of the aircraft. The notice does not name the operators, say how many times the nose pitched, or when. No aircraft is grounded.

Airlines have to measure the freeplay, then repeat the check, repair the parts, or replace them, depending on what they find. The steps are in a Boeing alert bulletin dated 12 June 2025. The rule, AD 2026-20-14, takes effect on 23 November 2026. From that day, operators follow the timetable in the bulletin. Where the bulletin counted from its own publication, the FAA has substituted 23 November. The same inspections were proposed on 9 January and, aside from small editorial changes, the final rule is the proposal.

Canadian North asked the FAA to give operators 36 months for the first inspection instead of 12, so the work could wait for a heavy maintenance visit and for parts to be in stock. United asked for a longer gap between repeat inspections on aircraft that already had new hinge bearings, and it asked the agency to count checks done after a Boeing message to airlines on 27 May 2022. Alaska asked to repair or replace the parts and skip an interim check the bulletin sets at 3,100 flight hours or six months. The FAA refused. It said the timetable is what safety requires, including on parts that are new or have just been replaced, and that an airline can still ask for more time if it shows the change would remain safe. The FAA said work already done under the 2022 message is already allowed for in the bulletin, so it did not add a separate credit. Boeing and the Air Line Pilots Association were among five commenters who supported the proposal unchanged.

The FAA puts the measurement at six hours of work. At the $85 an hour it used for the estimate, that is $510 an aircraft and $1,013,370 across the 1,987 US-registered aircraft, before any parts. A repeat of the measurement costs the same again. The agency said it cannot tell how many aircraft will need parts changed, and it has no firm price for those parts. The 1,987 figure is the US registry only. It is not a count of aircraft already found with excessive freeplay, and it is not the size of the fleet worldwide.